Canadian smocking by joining two points-design 3 - "Matrix design"

Canadian smocking by joining 2 points.design 2-Braid

Rows of aCanadian smocking by joing 3 points" "Arrows"

I call this design" Arrows".There should be name to each graph for reference .Then it will be easy to follow the tutorial

Canadian smocking by joining 2 points Shell design

Shell pattern

In shell pattern two dots are connected with pulled stitches which are knotted and separated by a slack knotted stitch.
Mark squares of 2 .5 cm x 2.5 cm on the wrong side of the fabric. Mark the red diagonal lines that represents pulled stitch. Mark the numbers 1,2,3,4,....while learning, as it will be easier to follow the diagram.
.Stitch with 3 strands of Anchor thread of the colour that matches the fabric. Folds look good if satin material is used.Follow the steps and stitch all the rows.2 rows of the squares are used at a time.  I have explained them with images. please see below.

How to do Canadian smocking

In Canadian smocking folds are created by pulled stitches alternated by slack stitches at equal intervals using a grid of dots as guide line. Usually it is worked on the reverse of the fabric except for ” The flower “design. When fabric is gathered from the back side beautiful pattern is formed in the front .This type of smocking is not as elastic as English smocking. Beautiful cushions and bags can be prepared with this type of smocking. Canadian smoking is also called North American smocking and Lattice smocking. This type of smocking is very quick and easy to do . The neatness of the work depends upon the grid of dots that is marked on the fabric. I prefer to draw square graph of required dimension. It is easy to draw squares of required width by using ruler of the same width. That is if you want to draw squares of 2” use a scale of 2” wide.

Preparation of the fabric

Step 1

Iron and remove wrinkles if there are any.

A margin of required width is left by drawing margin lines on all the four sides of the fabric using a tailor's chalk.Now we have to mark squares of required width.

Step 2

Use a scale of required width and draw parallel lines to the margin of one side.

Step 3

In the same manner draw perpendicular lines
Thus the fabric is divided in to squares of required width.I prefer to produce the lines beyond the margin lines as it helps while finishing the work.
Now the fabric is ready to smock.

In Canadian smocking folds can be created in three ways.
1. By joining two points
2. By joining three points and
3. by joining 4 points.
Further variations can be made under each method by changing size of the square, by leaving gaps between rows or columns and by drawing rectangle grid instead of square grid. Using flower type stitch in-between.In my next post I will explain the method of smocking various designs.